top of page

The board integrates with PX4FMU+PX4IO
Pixhawk is with new 32 bit chip and sensor technology
32 bit 2M flash memory STM32F427  Cortex M4, with hardware floating point processing unit
Main frequency: 256K, 168MHZ RAM
32 bit STM32F103 backup co processor
L3GD20 3 axis digital 16 bit gyroscope
LSM303D 3 axis  14 bit accelerometer /magnetometer
MPU6000 6 axis accelerometer / magnetometer
MS5611 high precision barometer
5* UART, 1*compatible high voltage, 2*hardware flow control
Spektrum DSM/DSM2/DSM-X satellite receiver compatible input
Futaba SBUS compatible input and output
PPM signal input
RSSI (PWM or voltage) input
3.3 and 6.6VADC input
External USB MICRO interface

- Advanced 32 bit CortexM4 ARM high performance processor, can run RTOS NuttX real time operating system;
- Integrated backup power supply and failure backup controller, the main controller can be safely switched to backup control;
- Provide redundant power input and fault transfer function;
- 14* PWM/ actuator output;
- Bus interface (UART, I2C, SPI, CAN);
- Provide automatic and manual mode;
- Color LED lamp;
- Multi tone buzzer interface;
- Micro SD to record flight data;

Gps Ublox neo M8N:

his is the new Ublox Neo-M8N GPS module that includes a QMC5883L digital compass. This module has a high level of sensitivity and features active circuitry for the ceramic patch antenna. It also comes enclosed in plastic case to protect the module from the elements. This modules outputs precise position updates at 10Hz and also has a rechargeable backup battery for warm starts. The Ublox NEO-M8N is configured to run at a baud rate of 38400 and ships for use with Pixhawk and APM (you might need to modify the cable to fit your autopilot board).

The most important improvement with this module is the vast sensitivity it offers. This modules receives concurrent reception from GPS/QZSS, GLONASS and BeiDou meaning that you should get an excellent signal no matter where you are in the world. Not only does it have this excellent reception capabilities, it maintains its low power consumption.




Ublox Neo-M8N module Industry leading

–167 dBm navigation sensitivity

Navigation update rate up to 10 Hz

Cold starts: 16-18s

LNA MAX2659ELT+25 x 25 x 4 mm ceramic patch antenna

Rechargeable 3V lithium backup battery

Low noise 3.3V regulator

Power and fix indicator LEDs

Protective case

Package included:
1 x 2.4.8 Pixhawk main control  

1x Gps M8n

1x gps stand holder

1x power module

1x pix shock observer 
1 x Safety switch  
1 x Flight control shell
1 x Buzzer
1 x 6pin to 6pin line  
1 x 4Pin to  4Pin line
1 x 3pin DuPont line 

Pixhawk 2.4.8 +Gps ublox M8n+power module set

    bottom of page